INSTRUCTIONS
SINKITS SINK CLIPS
Sinkits sink clips instructions
Determine the number of Sinkits required. Mark the locations to be drilled approximately 3/4” from sink rim. Drill .25” diameter holes a minimum depth of ½”, a depth of ¾” is preferred when possible.
​
Bend tab away from clamp body (this will preload the clamp to enable it to stay inserted until tightened), insert clamp fully into hole, making sure clamp post bottoms out in the hole or clamp body rest against sink rim. Tighten clamp against sink rim. Do not over tighten.
​
Important: Binding tab must be bent far enough to create pressure when inserting clamp.
Watch a quick demonstration video below
Disclaimer and limitation of liabilities: Sinkits sink clips are designed for the purpose of attaching undermount sinks to solid surfaces such as stone, quartz or products of similar characteristics. The end user must determine the number of clips and placement required to properly complete the task and that the substrate the clips are being inserted into has the characteristics needed to support the product being attached. Persons installing Sinkits must be familiar with the process of undermounting sinks beneath countertops and that person assumes the responsibility of insuring the clips are properly secured. All responsibility as to the appropriate use of this product is the responsibility of the user. This product is intended to be used by professional personnel who are competent to evaluate the limitations and proper placement and application of its intended use and that person should accept the responsibility that the product is adequately installed.